Leg-focused bodybuilding: a 4-day plan

Who this plan suits

For experienced lifters with controlled leg presses, hinges and single-leg work. You should recover between leg sessions. Free barbell squats are not a requirement for this leg-press-based programme.

Set up your training week

Monday does not work this week? Start the first session on Tuesday and move the following days along. Keeping the order helps every muscle group get its turn. Trying to catch up on two missed workouts in one evening usually makes the week harder to manage. Continue with the next session when you return.

How to use the sessions

2 × 8–12 means eight to twelve repetitions, a rest, then a second set. For a single-sided movement, the number applies to each side. Follow the exercise order shown. For dumbbells, record the combined load here: two 10 kg dumbbells mean 20 kg. If you use just one dumbbell, record that one weight.

Warm up for your workout

Move gently for a few minutes until you feel ready for the first exercises. Rehearse the first leg and pressing movements with a light load. Add another preparation set closer to your working load if needed. Finish these sets before they become tiring. A later exercise that is unfamiliar also deserves a light practice set.

Find your starting weight

Choose the weight for the prescribed reps and leave roughly one to three clean repetitions in reserve (RIR). In free-weight squats, presses and hinges, a controlled final rep matters more than complete exhaustion. Leave more room when learning a variation. Extend the listed rest if the next repetition would otherwise be uncontrolled.

The last repetitions can feel hard while still looking like the first. If you have to swing or cut the movement short, lower the weight. Finding the right load takes practice, especially at first. Note the seat setting and grip too, so you can set up quickly next time.

Add repetitions, then weight

Keep the weight and add reps within the range. For 3 × 8–12, you might move from 8/8/8 to 10/9/9 and eventually 12/12/12. When every set reaches the top with the same execution and chosen reserve, try the smallest weight increase. Reps can then return toward the bottom. If control disappears, the jump was too large. Do not add weight and sets together.

Your first four to eight weeks

Use the first sessions to learn the order and find your weights. Then the comparison becomes useful: the same exercise, a few more repetitions or a heavier dumbbell. Give the plan four weeks to begin with. If you are recovering and progressing, continue through week eight, including weeks when the weight stays the same.

Adjust the focus

If leg workload rises substantially, start with three rather than four leg-press sets and one rather than two split-squat sets. Split-squat reps are per leg. Add them back after stable recovery; avoid introducing more running and more leg sets in the same week.

When an exercise stops progressing

1. One weaker day is not a plateau. Compare the same exercise, similar rests and consistent technique across several sessions.
2. Check whether sleep was short, rests were shorter or the previous exercise was harder. Repeat under comparable conditions first.
3. After three or four comparable sessions without progress, drop the load by a small step and build reps again. Adding sets is not the first adjustment.
4. If several exercises decline together and fatigue persists, reduce working sets for a week, for example from two to one. Resume with loads you can control.

When to end a set

End the set when you clearly shorten the movement, need momentum or lose control of your position. Muscular effort and faster breathing are expected. Sudden sharp pain, dizziness or unusual symptoms are reasons to stop the exercise or session. Have persistent or recurring pain assessed before continuing to load the affected movement.

Manage your weekly workload

Count the work a muscle does in compound lifts as well as its direct exercises. Chest presses also train your triceps; rows involve your biceps. Extra arm sets add to that workload. Keep the volume steady while you gain controlled repetitions or lift more weight. Add a set when a particular muscle needs more work and you recover well before training it again. If performance drops and fatigue lingers, reduce accessory sets first.

Know where to start next workout

Create the sessions as LiftPal routines. Save weight, reps and RPE, your rating of effort. Use your history to compare the same exercise with the same settings before adding weight or sets.